Starry Night Halos aims to make installation of our products as easy as possible! All Starry Night Halos halos and strips are 5v therefore needing our Plug and Play Harness to properly power them. Our RGBA + Chasing Plug and Play Harness takes the 12v from your battery and steps it down to 5v to power the halos or strips. Our inline fuse on the power wire provides protection to your product. If any short would happen, the fuse would blow before anything else.
To make installation as easy as possible, Starry Night Halos designed the Plug and Play Harness with ring terminals pre-attached! Simply plug the RGBA drivers into the pre-wired connectors, connect the halos or strips into the drivers, then the positive and negative ring terminals to the appropriate battery post. Make sure to remove your fuse during wiring and then reinstall after!
How to Order:
Choose the Plug and Play Harness with the driver connections that are desired. Each of our drivers controls 2 connections. For example, to install 4 halos and 4 LED strips, simply choose our 4 driver connector harness.Please be aware that this product is the harness only and will not come with switchback drivers. You must order our RGBA+Chasing+Switchback halos in the appropriate size and a driver will be supplied.
- 1, 2, or 4 Driver Connection RGBA+Chasing Plug and Play Harness
- 7.5amp Fuse Included
- Waterproof Fuse Holder
- Installs in minutes
Mount all controller receivers inside of your vehicle. Failure to do so will void the warranty and cause issues with your controller and halo kit.
All of Starry Night Halos are 5v and must be powered through the Plug and Play Harness to avoid frying the halos.
Do not touch Starry Night Halos with bare hands. We recommend using an ESD wrist strap when dealing with any of our products. Touching the diodes while the halos are powered can burn that diode out on the halo causing failure of the halo.
Use the 3m tape provided to mount your Starry Night Halos. Do not use bare beading wire to mount the halos. If the bare beading wire touches a solder joint, it will cause a short and ruin your halo kit.
The Starry Night Halos Bluetooth controller must be powered through the Plug and Play Harness. DO NOT peel the "void if removed" sticker off add power and ground wires to the other end of your Bluetooth controller.
Running your Starry Night Halos while your headlights or fog lights are on can greatly reduce the life of your halos. Do not run HID bulbs in your fog lights if you are running fog light halos or you will increase the chance of failure of your halos.